HP LaserJet MFP Analog Fax Accessory 300 Fax Manual page 18

9
When connecting the fax accessory to a phone line, ensure that the
Note
phone line being used for the fax accessory is a dedicated line that is
not used by any other devices. This line should be an analog line,
because the fax will not function correctly if connected to some digital
PBX systems. If you are unsure of what type of line you have, contact
your telecom provider. Also, HP recommends using the phone cord
that comes with the fax accessory to ensure that the accessory
functions correctly.
The phone wall jack is electrified and you might receive an electric
WARNING!
shock if you touch the connector wires. When installing the phone
cable, do not touch the wall phone jack or, if you connect the phone
cable into the wall phone jack first, do not touch the wires on the
phone cable connector at other end.
10 Connect one phone cord connector (1) into the FAX connector
Making cabling connections - HP LaserJet 4345mfp
Figure 1-10
11 Connect the other end of the phone cord into the phone jack on
12 Plug the MFP AC power cord in and set the power switch to on.
This completes the installation of the fax card. Next, you need to
verify that the fax has been installed correctly and is operating, see,
"Verifying fax operation" on page 11.
10 Chapter 1 Setting up
Close the formatter cage door and replace the MFP formatter
cover.
(2), see Figure 1-10. Push it in until it "clicks."
the wall. Push the connector in until it "clicks."
LAN Cable (if used)
Phone cord
ENWW