Arrow ED1012 B1 Owner's Manual & Assembly Instructions page 24

Step 11
SX24 ctr
(48)
Each screw and bolt in the wall
requires a washer.
CORRECT
1
Slide side siding into channels
of corner and splice posts, at edge
upward, bottom edge down resting
on oor frame. Always follow this
pattern. Fasten bottom edge and tab
of stud to oor frame using screws.
Fasten center to stud with screws.
Do not fasten top edge yet.
2
Install side siding as before.
Note how the slot in bottom edge
must overlap at edge of last siding.
Fasten both siding panels to stud at
this overlap.
3
Install side siding to the top as
before.
4
From inside building, fasten siding
to corner posts and splice post using
screws.
5
Repeat steps 1 through 4 opposite
side of building.
NOTE
Be careful to install the correct
panel in each position as shown.
The oor frame must be square
and level or holes will not align.
(56)
INCORRECT
Bottom
Edge
Flat
Edge
Parts Needed For
Side Siding
STEP
4
STEP
5
End
View
Be certain all siding
overlaps are fastened
with a single screw
24
6287 Side Siding (12)
6287
6287
6287
Washer
STEP
1
STEP
3
STEP
2
THIS SCREW MUST
FASTEN TAB OF STUD