Pentair IntelliFloXF Installation And User Manual page 5

The IntelliFloXF and IntelliProXF
®
can be programmed to run at specific speeds and time
intervals for maximum operating efficiency and energy
conservation for in-ground pools.
• The pump can operate from 450 RPM to 3450 RPM
with four preset speeds of 750, 1500, 2350 and 3110
RPM
• The pump can be adjusted from the control panel to
run at any speed between 450 RPM to 3450 RPM
for different applications
• Up to 8 programmable speeds
• Pump control panel alarm LED and error messages
warn the user against under and over voltage, high
temperature, over current and freeze protection
• Communicates with EasyTouch
or SunTouch Control Systems or IntelliComm
®
Communication Center via a two-wire RS-485
cable connection
• Self-priming for easy start-up
• Totally enclosed fan-cooled (TEFC) motor design
• UL/CUL/NSF
Union Adapter Installation
Installing the locking union onto the pump:
1. Glue the PVC union adapter fitting to the PVC pipe.
The adapter accepts 2.5" PVC pipe internally or a
3" PVC coupling externally.
Note: Be sure that the groove for the retainer ring is
on the end opposite your glue joint.
2. Slip the nut onto the fitting.
3. Place the flat side of the retainer ring against the
adapter on the grooved end.
4. Gently flex the locking clip union nut retainer ring into
its place in the groove on the adapter.
5. Start snapping it in at one end of the ring and work
your way around.
The tab features should point out away from the nut
and the glue joint towards the sealing surface.
6. Slide the nut over the ring and attach it to the pump.
Union Nut and Adapter
Variable Speed Pump
®
, IntelliTouch
® ®
®
Only install the
retainer ring with the
tab features pointing
away from the nut.
XF
®
INTELLIFLO and INTELLIPRO
PUMP OVERVIEW
Operator Control
Panel
AC Power
Connection
Compartment
Cover Assembly
)
(Gasket and Screws 4x
Slip the nut onto the fitting.
Snap retainer ring around the adapter.
Slide the nut over the adapter
XF
®
Variable Speed Pump Installation and User's Guide
Communication port to
connect to automation
system via RS-485
cable (not shown).
Union Kit
(Suction and Discharge Fittings)
1