Pentair IntelliFloXF Installation And User Manual page 14

10
MENU
Pump Menu: Settings
SETTINGS
Setting Password
1. Check that the green power LED is on.
Temperature Unit
2. Press Menu. Press Select to select "Settings".
3. Use the Up or Down arrow to scroll to "Password".
Screen Contrast
4. Press Select. The default setting is "Disabled".
5. To change this setting, press Select. Press Up or
Down arrow to change the setting to "Enabled" and
press Enter to save.
6. Press the Down arrow. "Password Timeout" is
displayed.
7. The factory default time is 10 minutes. This means
the IntelliFloXF Variable Speed Pump will go into
®
Password Protection mode 10 minutes after the last
control panel key is pressed.
8. Press Select to change time setting from 1 minute
to 6 hours and press Enter to save.
9. Press Down arrow and then press Select on "Enter
Password" to change the password.
10. Press the Left or Right arrows to move cursor and
press Up or Down arrow to change the password.
11. Press Enter to save. To cancel any changes, press
Escape to exit without saving.
Entering Password
1. Press any button (besides the speed button) to prompt
the screen for a password.
2. To enter password, use the Left and Right arrows to
move the cursor and the Up and Down arrow button
to scroll through the digit then press Enter to confirm.
XF
®
INTELLIFLO and INTELLIPRO
Pump Address (1-16) Default: ADDRESS 1
Set Time
(hr:mm) Default: 12:00 AM
AM/PM
Set AM/PM
24 hr.
Fahrenheit - Default: F°
C° Celsius
(1-5) Default 3
English - Default: English
Language
Set Min Speed
(450 RPM - 1700 RPM) - Default: 450 RPM
Set Max Speed (1900 RPM - 3450 RPM) - Default: 3450 RPM
PASSWORD
Disabled/Enabled - Default: Disabled
Password Time Out (1 min. - 6 hours) Default:10 minutes
Enter Password (xxxx) Default: 1234
XF
®
Variable Speed Pump Installation and User's Guide