Pentair IntelliFloXF Installation And User Manual page 16

12
MENU
Pump Menu: Speeds 1-8
SPEED 1-8
Set Speeds 1-8 in Schedule Mode
In Schedule mode, Speeds 1-8 can be programmed
to run a certain speed at a certain time of day. To run
a scheduled speed, press Start/Stop. The screen will
display "Running Schedules" when it is ready to run
a scheduled speed. If Start/Stop is pressed while a
scheduled speed is running, "Running Speed _" will be
displayed (see far left image).
1. Press Menu.
2. Use Up or Down arrows to scroll to "Speed 1-8",
then press Select.
3. Use Up or Down arrows
speed you wish to set and schedule.
4. Press Select (display will be highlighted) and
scroll to "Schedule".
5. Press Enter.
Down arrow ("Set Speed" will display) and
6. Press
press Select to change. Use the Up or Down
arrow to adjust speed.
7. Press Enter to save the new speed.
8. Press the Down arrow again, "Set Start Time" will
Press Select -
display.
minute column.
9. Use the Up or Down arrow to change the time
and the Left or Right
minutes to hours.
10. Press Enter to save the new start time setting.
11. Press Down arrow -"Set StopTime"will
Select. Repeat Steps 8-9 to set stop time.
12. Press Enter to save the new stop time setting.
13. Press Start/Stop.
The IntelliFloXF Variable Speed Pump will prime and
®
begin to run the programmed schedule at the specified
start time.
When running in Schedule or Egg Timer mode, the
countdown time (T 00:01) showing the hours and
minutes remaining is displayed.
Programming Schedule for Constant Run
A speed cannot be programmed with the same start
and stop times. To run a speed without stopping, set
the Start time one minute after the stop time.
Example: A single speed will run non stop if programmed
with a Start Time of 8:00 AM and a Stop time of 7:59 AM.
XF
®
INTELLIFLO and INTELLIPRO
and press Select for the
the cursor will highlight the
arrow to move cursor from
display.Press
XF
®
Variable Speed Pump Installation and User's Guide
12:15p
Schedule
Set Speed
Setting Schedule Mode
Note: The pump will not run the scheduled speeds until the
Start/Stop button is pressed (LED on) to place the pump in
Schedule mode.
Note: When two speeds are scheduled during the same run
time the pump will run the higher RPM Speed regardless of
Speed # in use.
Note: The most recent command, Manual or Schedule, takes
priority regardless of speed number RPM.
MENU
Pump Menu: External Control
EXT CONTROL
External Control
This function is for programming speeds that will run
when the IntelliComm Communication Center sends it a
®
command. For example, Terminal 3 and 4 in IntelliComm
system will correspond to External Control Program #1.
(5 and 6 to Ext Ctrl #2). Use the External Control feature
to program the IntelliComm system power center.
To access the External Control menu:
1. Check that the green power LED is on.
2. Press the Menu button.
3. Use Up or Down arrow to scroll to "Ext. Ctrl.".
5. Press Select. "Program 1" is displayed.
6. Press Select to change the speed. The "RPM"
number will highlight.
7. Press Up or Down arrow to change the RPM
setting.
8. Press Enter to save the setting.
Note: To cancel any changes, press the Escape
button to exit without saving.
9. Press Escape to return to set Program 2.
10. Use Up or Down arrow to scroll to "Program 2".
11. Repeat Steps 6 through 10 to set Program 2, 3,
and 4.
12:15p
750 RPM
T 1:05 150 WATTS
Running Speed 1
Display During Schedule Mode