Pentair IntelliFloXF Installation And User Manual page 23

Connecting the Pump to a SunTouch
The IntelliFloXF and IntelliProXF
®
Pumps can be controlled by a SunTouch control system
via the RS-485 communication cable.
To connect the pump RS-485 communication cable
to the SunTouch control system circuit board:
1. Unlatch the front door of the SunTouch system
power center and open the door.
2. Loosen the retaining screw on front panel. Open
the hinged front panel to access the electronics
compartment.
3. Route the two conductor cable up through the
power center grommet opening located on the
left side, and up through the low voltage raceway
to the motherboard.
Control System
®
Variable Speed
®
J11
COM PORT
RS-485 Communication
Cable (P/N 350122)
230 VAC Power to Pump
SunTouch Control System Circuit Board
XF
®
INTELLIFLO and INTELLIPRO
Switch OFF main system power to the SunTouch
system power center before making any
connections.
4. Strip back the cable conductors 6 mm (1/4").
Insert the wires into the screw terminals
(provided). Secure the wires with the screws. Be
sure to match the color coding of the wires;
YELLOW to YELLOW and GREEN to GREEN.
5. Insert the connector on the COMPORT (J11)
screw terminal on the SunTouch system circuit
board.
6. Close the control panel and secure it with the
retaining screw.
7. Close the front door. Fasten the spring latch.
GAS
HEATER
RESET
Pump
Drive
XF
®
Variable Speed Pump Installation and User's Guide
19
CLNR