Modifying a Block Diagram
Using the keypad you can modify the parameter values within a function block.
Using the DSE Configuration Tool, you can modify the parameter values within a function block, and also make and
break links within the shipping configuration. The Help in the DSE Configuration Tool explains this process.
Programming Rules
The following rules apply when programming:
Function block output parameter values cannot be changed (because they are a result of the function block's
Function block input parameter values that receive their values from an internal link in the Block Diagram cannot
Saving Your Modifications
If parameter values have been modified, the new settings must be saved. The Drive will then retain the new settings during
power-down. Refer to Chapter 8: "The Keypad" - Saving Your Application.
DSE Configuration Compatibility
All versions of 890 control board firmware are supported by V2.19 (or newer) DSE or DSELite.
AC890PX Frame M
processing)
be changed (as they will change back to the value they receive from the link when the Drive is running).
D-3
Programming