Chapter 10 Routine Maintenance & Repair - Parker AC890PX Product Manual

Safety Information
Product Warnings
DANGER
Risk of electric shock
Hazards
DANGER! - Ignoring the following may result in injury
1. This equipment can endanger life by exposure to rotating
machinery and high voltages.
2. The equipment must be permanently earthed due to the high
earth leakage current, and the drive motor must be connected
to an appropriate safety earth.
3. Ensure all incoming supplies are isolated before working on
the equipment. Be aware that there may be more than one
supply connection to the drive.
4. There may still be dangerous voltages present at power
terminals (motor output, supply input phases, DC bus and the
brake, where fitted) when the motor is at standstill or is
stopped.
WARNING
Hot surfaces
5. For measurements use only a meter to IEC 61010 (CAT III or higher).
Always begin using the highest range.
CAT I and CAT II meters must not be used on this product.
6. Allow at least 10 minutes for the drive's capacitors to discharge to safe
voltage levels (<50V). Use the specified meter capable of measuring up
to 1000V dc & ac rms to confirm that less than 50V is present between
all power terminals and between power terminals and earth.
7. Unless otherwise stated, this product must NOT be dismantled. In the
event of a fault the drive must be returned. Refer to "Routine
Maintenance and Repair".
Caution
Refer to documentation
Earth/Ground
Protective Conductor
Terminal