Operation - Westfalia GM941 Instruction Manual

Operation

There is no need to force the pole pruner into the cut. Run the motor
and only lightly press on the tool. If the saw jams in the cut, do not try
and pull the tool out by force.
Cutting Branches – Cutting thick Branches on a Tree

When cutting off larger
branches, you should first
cut into the branch from
below. First cut into the
branch from below outside
the place where you intend
to cut off the branch. The
cut should go from one
third to halfway through the
branch (step
prevents the branch from
buckling when you cut into
the branch from the top
outside the first cut (step
2).

Finally, cut off the stump
with one clean cut (step 3).

Before you start cutting, attach the branch at the limit stop of the
saw.
Pole Pruner
1). This
15