Working With The Hedge Trimmer - Westfalia GM941 Instruction Manual


Tilt the cutting bar in order to adjust the desired working angle.

Only tilt the cutting bar when the motor is switched off!

NOTICE: After shutting down the engine the blades of the cutting
bar may not immediately come to a standstill. Always wait for the
blades to stop moving before setting the unit down.

Working with the Hedge Trimmer


Before cutting bushes, scrubs or hedges, remove thick branches or
similar material. Cut them out with the pole pruner.

Make sure that there are no small animals hidden in the bushes or
hedges.

There are different cutting techniques and certain seasons to be
observed when trimming hedges or bushes. For detailed infor-
mation see appropriate technical literature.

Please note the local rest periods when working with the hedge
trimmer in order to avoid disturbances.

Please also note that is may not be legal to trim hedges year round
in your area for the protection of animals.

Before cutting, inspect the area that the hedge trimmer will be used
in. Make sure not to touch hard objects such fences, poles, stones
etc. This may cause damages to the cutting bar.
Hedge Trimmer
17