SAB xFinder 2 User Manual page 21

It shows the frequency that has signal of you
connected satellite.
1. Press [F3] button to switch the show of X
axes between RF and Freq.
2. Press [F4] button to set the DiSEqC.
Press [ok] button on Motor item to
enter set motor mode, now you can
press [VOL+/VOL-] button to move the
motor from west or east. And press
[exit] button to exit this mode.
DiSEqC1.0: You can use [VOL+/VOL-]
key to switch options. There are
several options for your selection:
i. Disable: without DiSEqC.
ii. 1/2, 2/2: two ports DiSEqC
iii. 1/4, 2/4, 3/4, 4/4: 4 ports DiSEqC
DiSEqC1.1: You can use [VOL+/VOL-]
key to switch options. There are
several options for your selection:
i. Disable: without DiSEqC.
ii. 1/8, 2/8... 8/8: 8 ports DiSEqC.
iii. 1/16, 2/16...16/16: 16ports
DiSEqC.
3. Press [CH+/CH-] button to change the
begin dBm of Y axes.
4. Press [VOL+/VOL-] button the current
frequency by 1MHz. Or number buttons to
change the current frequency by the
number multiply 1MHz, and press [0] button
to switch add or minus.
5. Press [red] button to enter into Bandwidth
Setting menu. Now you can change Start
Freq by [VOL+/VOL-] button or number
keys, the available range are "950MHz ~
2150MHz". Set BandWidth by [VOL+/VOL-]
button among 50MHz, 100MHz, 300MHz,
600MHz, 900MHz.
6. Press [green] button to switch power
between 13V and 18V.
7. Press [yellow] button to switch 22K
between ON and OFF. When this item is
switched to "ON", Xfinder will receive TV
and radio input signal from 22K port. If the
item is switched to "OFF", the Xfinder will
receive all signals from 0K port.
8. Press [blue] button to enter into Log Setting
menu. You can save spectrum, load
spectrum and compare the spectrum to old.
Press [ok] button on save item, you
will see the menu like
below:
It has a default name in Rename item,
you can rename it. Press [green]
21