Basic Operations - SAB xFinder 2 User Manual

8. Basic Operations

8.1 Turn on Xfinder
First, press the Device's Main [Power] button to
turn on the unit. When the Xfinder is first used,
there will play the first channel from the default
Channel List. If the Xfinder is not first used,
Xfinder will play the same channel as last time
before turning off.
? Frequently Asked Question
Q: The power of my Xfinder has been turned
on and not in Standby mode, but the TV
screen showed nothing:
A: Make sure the TV set has been set to the
correct video input (not the TV channels). For
example, if you have connected the unit with the
Video1 input of the TV set, the TV set has to be
switched to Video1.
Q: The power of my Xfinder has been turn on
and not in Standby mode, but the TV
screen showed nothing except one box
with "No Signal" image.
A: That means the channel, which you select, is
no signal. It could be several causes:
The channel which you select is not in your
1
allocate satellite. The simply solution is to
change channel.
The signal of current TV channel is too
2
weak. You can try to change channel to
other strong signal channels. If the
problems still exist, please consult your
local dealer or other professionals for
technical service.
You use the Dual LNB, and you need
3
Modify LNB Type
8.2 Power
Press [Power] Key can enter the Standby
1
state
In Standby state, press [Power] Key again
2
can call back the unit and go on play the
previous channel
User can also disconnect the device's main
3
power to end the Standby state.
Channel Up/Channel Down
8.3
In full screen, press [CH+/CH-] to change
channel.
8.4 Volume Up/Volume Down
In full screen, press [VOL+/VOL-] to adjust
volume.
8.5 Number
In full screen, use number key and press [OK]
on the Remote Control Unit to change channel.
Mute
8.6
Press [MUTE] key to mute the sound and
1
the screen will show up mute OSD.
Press [MUTE] key again to restore sound.
2
Pause
8.7
In playing mode, press [Pause] key, the
1
picture will be paused, but the sound of the
channel will still continues.
Press [Pause] key again, the screen's
2
picture will skip over to the current playing
picture, and the sound of the channel will
correspond playing.
Audio
8.8
In full screen, press [AUDIO] key can open
1
the "Audio" window on the screen.
11
.