Constellation - SAB xFinder 2 User Manual

Press [ MENU ] key to draw back to "Main"
Menu.

11. Constellation

When you enter to "Constellation" menu, you will
see the screen like below: It show the picture of
constellation.
DVB-S Constellation
DVB-S2 Constellation
Note If current TP has not signal, it will show
:
ruleless white dot. And the stronger the signal,
the higher the concentration of white spots
22 k
You can use [red] key to switch "on/ off". When
this item is switched to "ON", Xfinder will receive
TV and radio input signal from 22K port. If the
item is switched to "Off", the Xfinder will receive
all signals from 0K port.
DisEqc Setting
Press [green] key enter "DisEqc Setting" Menu,
you will see the screen like below:
1.DiSEqC1.0: You can use[Volume Up/ Volume
Down]key to switch options. There are several
options for your selection:
a) Disable: without DiSEqC.
b) 1/2, 2/2: two ports DiSEqC
c)1/4, 2/4, 3/4, 4/4: 4 ports DiSEqC
2.DiSEqC1.0: You can use[Volume Up/ Volume
Down]key to switch options. There are several
options for your selection:
a) Disable: without DiSEqC.
b)1/8, 2/8... 8/8: 8 ports DiSEqC
c)1/16, 2/16....16/16: 16 ports DiSEqC
Frequency
You can input number keys to the Frequency,
The available range are "3000~13450 MHz"
Symbol Rate
You can input number keys to set the Symbol
Rate, the available range are
"1000~45000Ks/s"
Polarity
In "Polarity" item, press [Left/ Right] key to select
Horizontal or Vertical".
Start
Press [ok] key to start to draw the Constellation
12. Spectrum
When you enter to "Spectrum" menu, you will
see the screen like below:
20
.