ABB ControlMaster CM10 User Manual page 61

ControlMaster CM10, CM30 and CM50
Universal process controllers,
...Control / ...Loop 1 Output
Tracking
Source
Signal Source
Mode
In Auto
Auto + OP
When Enabled
When Enabled +
OP
Enable Source
IM/CM/B–EN Rev. H
1 1 1
/ , / and /
8 4 2
Enables the control output to be configured to follow a tracking signal when in
When in Manual control mode, the output can be adjusted by the user as normal. If the slew rate
function is enabled, the switching from Manual to Auto is bumpless. If the value set by the tracking
signal is different to that set manually, the output ramps to its expected auto value at the speed set in
the slew rate. If the Signal Source is set to None, tracking is disabled and the normal PID output (see
page 32) is provided as the control output.
Sets the source of the signal required to be tracked by the output in Auto control mode. If set to
, output tracking is disabled.
None
Selects if the output slew rate function is enabled and when it applies.
Control output = tracking signal when in Auto control mode
Control output = tracking signal + change in
When enable source is active, control output = tracking signal when in
When enable source is active, control output = tracking signal + change in
control mode.
Sets the digital signal to enable output tracking.
. Applicable only if Mode = When Enabled or When Enabled + OP.
Note
DIN
output, when in
PID
7 Advanced Level
mode.
Auto control
control mode.
Auto
control mode.
Auto
output, when in
PID Auto
59