YOKOGAWA TA520 User Manual page 80

3.24 Common Command Group
*RST
Function Initializes the set-up information.
Syntax *RST
Example *RST
Description The same function can be performed by
displaying initialize menu and pressing
[Execute] soft key. For details, refer to the
TA520 Time Interval Analyzer User
*SRE
Function Sets the value of the service request enable
register/queries the current setting.
Syntax *SRE <NRf>
*SRE?
<NRf>=0 to 255
Example *SRE 239
*SRE?→239
*STB?
Function Queries the value of the status byte register.
Syntax *STB?
Example *STB?→4
Description For details of the status byte register, refer to
Chapter 4, Status Report.
"
*TRG
Function The same function as when the SINGLE key is
pressed is performed.
Syntax *TRG
Description GET (Group Execute Trigger) multi-line
message has also the same effect as this
command.
*TST?
Function Executes a self-test and queries the test result.
Syntax *TST?
Example *TST?→0
Description • The same function can be performed by
selecting [Board] from the self-test menu.
• [ ] will be returned if all the self test results
0
are satisfactory, and a value other than [
will be returned if an abnormality is detected
during the test.
*WAI
Function Waits for the command following
execution of the designated overlap command
is completed. This command will be ignored
even if it is sent since overlap commands are
not supported by this instrument.
Syntax *WAI
3-60
' s Manual.
"
]
0
"*WAI" until
IM 704310-12E