Two Notes Torpedo Studio User Manual page 38

Last
update:
torpedo_studio:torpedo_studio_user_s_manual http://wiki.two-notes.com/doku.php?id=torpedo_studio:torpedo_studio_user_s_manual
2017/11/08
15:11
The Low and High bands have the following parameters :
Gain: sets the gain of the band (except if Cut type is selected).
Freq: sets the center frequency of the band (or the cutoff frequency if Cut type is selected). It
can be set from 10 to 500 Hz for the Low band, and from 1 to 20 kHz for the High band.
Type: sets the shape of the band. Cut is a second order (-12dB per octave) low or high cut.
Shelf is a low or high shelf. Peak is a peak filter with a fixed 1.41 bandwidth.
The 4 middle bands are peak filters with the following parameters :
Gain: sets the gain of the band.
Freq: sets the center frequency of the band, from 20 Hz to 20 kHz.
Width: sets the width of the band, from 0.01 (very narrow) to 4.00 (very broad). 1.42 is a good
starting value.
5.10.2 Exciter
An exciter is very useful to give a tone a certain character, or to add presence, or "air", to the sound.
Exciter: Switch the exciter ON or OFF.
Low: Control the quantity of effect applied to the lower frequencies of the sound.
High: Control the quantity of effect applied to the higher frequencies of the sound.
http://wiki.two-notes.com/ Printed on 2017/11/10 22:17