Speaker And Mic - Two Notes Torpedo Studio User Manual

Last
update:
torpedo_studio:torpedo_studio_user_s_manual http://wiki.two-notes.com/doku.php?id=torpedo_studio:torpedo_studio_user_s_manual
2017/11/08
15:11
brings — that is, the power amplifier. Plug your device into the LINE input of the Torpedo Studio and
enjoy the typical sound of the Two notes electrically accurate virtual tube power amplifier.
Power Amp: Activate the power amplifier simulation by turning this parameter "On".
Model: Choose the circuit topology (Push Pull or Single Ended) and the tube type (6L6, EL34,
EL84, KT88).
Volume: Set up the output volume of your virtual power amplifier.
Presence: This setting affects the tube-stage frequency as regards loudness. From 0%
(medium boost) to 100% (low and high boost), this parameter can be seen a loudness setting.
Depth: This setting affects the bandwidth of the tube-stage. 0% means full bandwidth, and
decreasing that value will venter around the medium frequencies. As Depth is placed after
Presence, you may not notice its effect if Presence is set to a value close to 0%.
Pentode/Triode: Select how the tube is used, either in triode or in pentode mode. Pentode
mode has more headroom and volume than Triode, meaning that Triode tends to saturate
earlier and with a softer sound.

5.7.3 Speaker and Mic

You have access to 50 different cabinets, and each cabinet can be miked with one of the 8 available
microphones. Please refer to Part 7 to discover the microphone and cabinet library.
Spkr/Mic: Determines if you are using Two notes virtual cabinets ("Cab") or 3rd party IRs
("User").
Speaker: Determines which speaker cabinet model to use for the simulation.
Mic: Determines which microphone model to use for the simulation.
Click on the SPKR/MIC button to select your A then B cabinet and microphone combination. The
microphones and cabinets on A and B can be different or identical.
http://wiki.two-notes.com/ Printed on 2017/11/10 22:17