Advertisement
FIG 6
FIG 7
NOTE: The vacuum has an overheating protection device It will
automatically switch off if it is overheated eg. From blocked nozzles, full
dust container or unclean filters. If this happens, then turn off the
vacuum and unplug from power socket. Clean and allow at least 45
minutes for the motor to cool down before re-using.
FIG 8
Press the ON / OFF switch
to start the vacuum.
Fig 9 – 1
Crevice Tool – Fig 6 - 2
Use this to vacuum hard to reach places
The small accessories conveniently
attach the handle.
To fit: -
1.
Clip the attachment to the handle
Fig 6 -1
2.
Insert the 2 in 1 Upholstery Brush
into the attachment.
Fig 7 – A
3.
Hook end of the crevice tool onto
the hook on the handle. Then clip
the rounded top end into the
attachment as shown Fig 7 – B
OPERATION
Pull the power cable out until the
yellow mark is visible. Fig 8 – 1
If you can see the red mark the cable
has been pulled out too far. Fig 8 – 2
Press the retract button until it winds
back in.
FIG 9
Advertisement
