Roberts Revival mini Manual page 18

Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough
to give good reception. However, you may wish the Auto-scan function
to also be able to find weaker signals, possibly from more distant radio
transmitters. Your radio includes a local / distant option for the Auto-scan
function.
1. Press and release the On/Off control to switch on your radio.
2. If needed, press and release the DAB/FM button to select the FM
mode.
3. Press and hold the Info button to enter the FM menu.
4. Rotate the Tuning control until the display shows 'FM Scan Zone' then
press and release the Tuning control to enter the scan zone selection
menu. The current setting will be marked with an asterisk.
5. Rotate the Tuning control to switch between Local and Distant options
on the lower line of the display. The Distant option will allow the radio
to find weaker signals when scanning.
6. Press and release the Tuning control to confirm your selection. The
radio will then revert to the normal information display. The Local or
Distant setting is stored in the radio and remains in force until changed
or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
17
1
2
3
4-6