Battery Operation Using Alkaline Batteries - Roberts Revival mini Manual

Battery operation using alkaline batteries

(also see page 25)
1. Remove the battery cover on the back of the unit by pushing the battery
door in slightly and then downwards in the direction of the arrow.
2. Slide the switch inside the battery compartment to the Alkaline
position.
3. Insert four LR6 (AA size) Alkaline batteries into the spaces in the
compartment. Take care to ensure all batteries are inserted with the
correct polarity as shown inside the battery compartment. Then replace
the battery cover.
• Important: when using Alkaline batteries the battery switch must
be placed in the Alkaline position. Failure to do so could result
in serious damage to the batteries or radio.
• When the batteries are exhausted, the charge/low battery indicator
will show red for a short while.
may not be possible to switch the radio back on until the batteries are
replaced, or until the radio is connected to the mains adaptor.
• If the radio is not to be used for any extended period of time it is
recommended that the batteries are removed from the radio.
• We would recommend for economy that the Revival Mini is used via
the AC adaptor whenever possible with battery operation for occasional
use only. If extended listening using batteries is anticipated, then the
use of rechargeable batteries is recommended.
IMPORTANT: The batteries should not be exposed to excessive heat
such as sunshine, fire or the like. After use, disposable batteries should
if possible be taken to a suitable recycling centre. On no account
should batteries be disposed of by incineration.
Caution: Replace batteries only with the same or equivalent type. Danger
of explosion if the batteries are incorrectly replaced.
The radio will then switch itself off. It
Service
Size AA
Size AA
Alkaline NiMH
Size AA
1
Size AA
4