Install Control Card Cassette; Plug In Terminal Connector - Danfoss VLT 5000 Instruction Manual

7. Install • Fasten control card cassette by alternately
Control Card
Cassette
• Route control wires through clamp
• Connect control terminals (C) by firmly
• Install LCP by sliding bottom into guide slots
• Replace protective cover by positioning
• Plug cable from LCP into connector on
8. Plug in • Connect Modbus signal wire (RTxD+) to
Terminal
Connector
• Connect Modbus signal wire (Com) to pin
• Connect Modbus signal wire (RTxD-) to
• Plug EIA-485 connector into terminal port
• Close front cover panel and fasten with
12
tightening two captive screws (A). Tighten
to 8 in-lbs.
fasteners (B) and secure clamps with two
screws.
pressing them into connector receptacles.
NEMA 1 Drives
on cradle, then press into place ensuring
that connector on back of LCP is engaged.
guide pins at bottom of cover into holes
in bottom of chassis and snap top of cover
into place.
NEMA 12 Drives
main control card.
pin 1 of EIA-485 (formerly RS-485)
connector.
2 of EIA-485 connector.
pin 3 of EIA-485 connector.
at side of Modbus RTU option card.
NEMA 12 Drives
captive screws. Tighten to 7 in-lbs.
(C)
(B)
(A)
RTxD' (-)
Com
Pin 1
EIA-485 Connector
RS-485 Connector
MG.10.P2.22 - VLT is a registered Danfoss trademark
RTxD (+)