Secure Modbus Rtu Option Card; Wire Modbus Rtu Option Card Connector To Unit's Terminals; Install Ribbon Cables - Danfoss VLT 5000 Instruction Manual

4. Secure • On back of cassette, insert edge of
Modbus RTU
Option Card
• Secure opposite side of card with 2
5. Wire
Modbus RTU
Option Card
Connector to
VLT 6000
Terminals
• Wire Modbus interface connector (24 V
• Wire Modbus interface connector (RTxD)
• Wire Modbus interface connector (com)
• Wire Modbus interface connector
• Plug Modbus interface connector into
6. Install
Ribbon
Cables
• Connect control card cassette to hinge
• Connect ribbon cables.
MG.10.P2.22 - VLT is a registered Danfoss trademark
Modbus RTU option card into slot at side
of cassette (A).
self-tapping screws and washers provided
(B). Using a Torx T-10 screw driver, tighten
to 8 in-lbs.
NOTE
Use 18 to 22 gauge wire. Torque
terminals to 4.5 in-lbs. Modbus
interface connector terminals 5
and 6 are spares.
power) pin 1 to VLT 6000 terminal 12 or
13.
pin 2 to VLT 6000 terminal 69.
pin 3 to VLT 6000 terminals 39 and 61.
(RTxD') pin 4 to VLT 6000 terminal 68.
bottom of Modbus RTU option card.
NOTE
Ribbon cables must be recon-
nected to same connections
from which removed.
at top of drive.
Pin 1
24V in to terminal 12 or 13
RTxD to terminal 69 (-)
Com to terminals 39 and 61
RTxD'
to terminal 68 (+)
(spare)
(spare)
(B)
(A)
11