Continuous Bar Code Read - Motorola Symbol PL4507 Integration Manual

4 - 16 Symbol PL4507 Decoder Integration Guide

Continuous Bar Code Read

Parameter # F1 89h
Select Enable to allow decode processing to continue until the trigger event ends or the decode session time-out
occurs. User indications occur upon decoding each bar code. Select Disable to end decode processing upon a
valid decode as well. This mode does not apply to presentation mode.
NOTE Motorola strongly recommends enabling
Mode can cause accidental decodes when more than one bar code is in the imager engine's field of view.
*
Disable Continuous Bar Code Read
Multicode Mode
Parameter # F1h, A5h
Enable this parameter to allow multiple bar codes to decode upon one trigger event based on the programmed
multicode expression. The decoder reports a successful decode and provides user indication only if it decodes all
bar codes indicated by the multicode expression, otherwise the decode fails. Bar codes are transmitted in the order
defined in the multicode expression. Disable this to operate in normal decode mode.
This mode operates in Level trigger mode only. Also disable
always orient scanner at the same distance and angle (perpendicular).
*
Disable Multicode Mode
(00h)
(00h)
Picklist Mode on page 4-14 with this feature. Disabling Picklist
Enable Continuous Bar Code Read
Continuous Bar Code
Enable Multicode Mode
(01h)
Read. If you enable this mode,
(01h)