Table of Contents
Advertisement
6 - 8
Symbol PL4507 Decoder Integration Guide
Simple Serial Interface Default Parameters
This section describes how to set up the decoder with a SSI host. When using SSI, program the decoder via bar
code menu or SSI hosts commands.
Throughout the programming bar code menus, asterisks (
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
Table 6-3
lists the defaults for the SSI host. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Download data through the device's serial port using SSI. Hexadecimal parameter numbers appear in this
chapter below the parameter title, and options appear in parenthesis beneath the accompanying bar codes.
Refer to the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for changing
parameters using this method.
NOTE See
miscellaneous default parameters.
SSI Default Table
Table 6-3
Parameter
Select SSI Host
Baud Rate
Parity
Check Parity
Software Handshaking
Host RTS Line State
Decode Data Packet Format
Host Serial Response Time-out
*
Baud Rate 9600
*
Indicates Default
Appendix A, Standard Default Parameters
Parameter
Number
N/A
9Ch
9Eh
97h
9Fh
9Ah
EEh
9Bh
*
) indicate default values.
Feature/Option
(06h)
Option Hex Value for programming
via SSI command
*Restore Defaults
for all user preferences, hosts, symbologies, and
Default
N/A
9600
None
Disable
ACK/NAK
Low
Send Raw Decode Data
2 sec
bar code on
page
4-4.
Page
Number
6-9
6-10
6-11
6-12
6-12
6-13
6-13
6-14
Advertisement
Table of Contents
