Timeout Between Decodes, Same Symbol - Motorola Symbol PL4507 Integration Manual

Timeout Between Decodes, Same Symbol

Parameter # 89h
Use this option in presentation mode to prevent multiple reads of a symbol left in the Symbol SE4500's field of
view. The timeout begins when you remove the symbol from the field of view.
To select the timeout between decodes for the same symbol, available in 0.1 second increments from 0.0 to 9.9
seconds, scan the bar code below, then scan two numeric bar codes from
correspond to the desired interval. The default interval is 0.6 seconds.
Beep After Good Decode
Parameter # 38h
Scan a bar code below to select whether or not the decoder issues a beep signal after a good decode. If selecting
Do Not Beep After Good Decode, beeper signals still occur during parameter menu scanning and to indicate
error conditions.
*
Beep After Good Decode
(Enable)
(01h)
Appendix D, Numeric Bar Codes
Timeout Between Decodes, Same Symbol
Do Not Beep After Good Decode
(Disable)
(00h)
User Preferences 4 - 15
that