Table of Contents
Advertisement
Chapter 5. Power cord and rails
This chapter contains information about the installation and removal of power cords
and rails in the iDataPlex Rack Type 7825 cabinet.
Notes:
1. Remove the rack doors when you install and remove optional devices in the
2. You have to remove a door only if part of the rack cabinet is obstructed by the
Removing and installing a power cord
To remove a power cord, complete the following steps.
Figure 22. Removing and installing the power cord
1. Turn off the power to the system-board trays; then, remove the chassis from the
2. Unplug the power cord that you are working on from the PDU.
3. Remove the two M3 screws from the back of the rail and set them aside.
4. Pull the mounting plate and power cord toward the front of the rack cabinet.
5. Separate the power cord from the mounting plate; then, set the mounting plate
© Copyright IBM Corp. 2008
rack cabinet. All rack cabinets come with front and rear doors installed.
door as you install the optional device.
Mounting
plate
Mounting
post
rack. See the Problem Determination and Service Guide on the IBM
Documentation CD for instructions.
aside and dispose of the power cord.
Plug
mount
Power
cord mounting
bracket
M3
screws
Power
cord
35
Advertisement
Table of Contents
