Table of Contents
Advertisement
Installing the stabilizer feet
To install the stabilizer feet, complete the following steps.
Statement 2:
DANGER
Figure 9. Lowering the leveling feet
1. Use the wrench that comes with the rack cabinet to lower each of the four
2. Place a level on the cabinet and adjust the leveling feet until the cabinet is level
3. Tighten the jam nuts on each foot against the underside of the rack cabinet.
22
IBM iDataPlex Cluster Solution: Installation and Service Guide
v Always lower the leveling pads on the rack cabinet.
v Always install servers and optional devices starting from the bottom of
the rack cabinet.
v Always install the heaviest devices in the bottom of the rack cabinet.
leveling feet just enough so that they touch the floor.
front to back and side to side.
Leveling foot
Advertisement
Table of Contents
