Table of Contents
Advertisement
M6 screws
Left C bracket
Clip nut
Figure 29. Installing the optional device rails
b. Align the three retention tabs on the rail with the mounting slots in the wall
of the rack cabinet.
c. Place the retention tabs into the mounting slots and rotate the top edge of
the rail toward the rack cabinet wall.
d. Push the rail down until it stops.
e. Push the rail toward the front of the rack cabinet. When the rail is in
position, the rails front flange will be flush against the back of the rack
cabinet vertical rail.
f. Install the C-bracket on the front of the rack cabinet:
1) Align the holes in the C-bracket with the threaded holes of the rail.
2) Using two M6 screws, secure the C-bracket to the rail and rack cabinet.
3) Install a clip nut on the front of the C-bracket.
g. Repeat steps 1a through 1f for the remaining rail.
2. Install the device in the rack and plug the power cord into a PDU; then, turn on
the device. See the documentation that came with the device for instructions.
Left rail
M6 screw
Chapter 5. Power cord and rails
41
Advertisement
Table of Contents
