Removing And Installing Rails - IBM iDataPlex Rack Type 7825 Installation And Service Manual

To install a power cord, complete the following steps.
1. Align the mounting posts on the mounting plate with the slots in the plug mount
2. Position the entire assembly inside the left rail and align the mounting posts with
3. Use two M3 screws to secure the power cord and mounting plate to the
4. Plug the power cord that you are working on into a PDU.
5. Install the chassis into the rack and turn on the power to the system-board

Removing and installing rails

This section provides the information needed to install and remove the 2U/3U
chassis rails and optional device rails.
Removing and installing 2U/3U chassis rails
The 2U/3U chassis rails are used to secure 2U or 3U iDataPlex chassis enclosures
in an iDataPlex rack cabinet. If you are removing or installing the optional device
rails, see "Removing and installing optional device rails" on page 39 for instructions.
Retention clip
Figure 23. 2U/3U chassis rails
36
IBM iDataPlex Cluster Solution: Installation and Service Guide
and install the power cord onto the mounting plate.
the holes in the back of the power cord mounting bracket on the rail.
mounting bracket.
trays. See the Problem Determination and Service Guide on the IBM
Documentation CD for instructions.
Retention clip
Right rail
Retention tabs
Retention tabs
Power cord
mounting bracket
Left rail
Chasis stop