Table of Contents
Advertisement
Control Panel
8.2.4
Network
8.2.4.1
Configuring Ethernet communication (LAN)
netPI | NOIT-E-NPI3-51-EN-RE
DOC170801UM01EN | Revision 1 | English | 2017-09 | Released | Public
Open this page with Network > LAN.
In order to access this page you require the following access right:
Access to LAN (Ethernet network)
On this page you configure the Ethernet interfaces eth0, eth1 (both on
the side of the cloud) and cifx0 (on the side of the fieldbus). For each
Ethernet interface you can configure how to set the IP address:
·
The Edge Gateway is to obtain the IP address parameters automatically
from a DHCP server: Option DHCP.
The IP address parameters are manually entered by the user: Option
·
Fixed address.
The IP address parameters include the IP address, the subnet mask, the
Gateway address, and the IP addresses of the 1st and 2nd domain name
server.
The default IP address of the LAN connection port 2 is 192.168.253.1
with the subnet mask 255.255.255.0.
Column
Meaning
Name
displays the name of the LAN interface.
MAC address
displays the MAC address of the LAN interface.
Settings
Selecting the configuration method: Here you can select between
· DHCP (IP address parameters automatically obtained from a DHCP
server) or
· Fixed address (IP address parameters entered by the user)
If you enter the IP address manually, also always enter the subnet
mask and the Gateway address.
Domain Name
If you enter the IP address parameters manually, enter the IP address
System
of the 1st and 2nd domain name server.
Table 20: Table LAN: Meaning of the columns
If you want to permanently save the changes you made, click at
afterwards.
35/64
© Hilscher 2017
Advertisement
Table of Contents
