Arming In Stay Mode 1 - Bosch Solution 2000 User Manual

Control Panel
5.1.3

Arming in STAY Mode 1

STAY Mode 1 is only used when the perimeter and unused areas of the premises need to be
armed to detect an intruder from entering the premises. At the same time, you can move freely
within an area that is automatically isolated.
Only your security company can program zones automatically isolated in STAY Mode 1.
There are two different methods for arming the system in STAY Mode 1. Method one is
standard and always operates. Method two is optional and may be disabled by your installer if
you do not want to use single button arming.
Entry Guard Timer for STAY Mode 1
When arming the system in STAY Mode 1, an optional entry timer called Entry Guard Time for
STAY Mode is available. Use this entry timer to delay the sirens if a zone is not automatically
isolated and activated an alarm condition.
Entry Guard Time For STAY Mode is the delay time used for all zones except 24-hour zones
when the system is armed in STAY Mode 1 or STAY Mode 2.
If the Entry Guard Time for STAY Mode is programmed and a zone was not automatically
isolated is activated, the codepad beeps twice a sec until the entry timer expires or the
system is disarmed. If the alarm condition is not reset by entering your user code followed by
the [#] button (such as, [2580#]) before the entry time expires, the sirens activate into alarm.
Only your installer can program this feature.
Method One
Method Two
Tab. 5.6: How to Arm the System in STAY Mode 1
5.1.4 Arming in STAY Mode 2
STAY Mode 2 is only used when the perimeter and unused areas of the premise need to be
armed to detect an intruder from entering the premise. At the same time, allowing you to
move freely within an area that is automatically isolated. Any Master Code or Installer Code
user can program zones to be automatically isolated in STAY Mode 2.
Enry Guard Timer for STAY Mode 2
When arming the system in STAY Mode 2, an optional entry timer called Entry Guard Time for
STAY Mode is available. Use this entry timer to delay the sirens if a zone is not automatically
isolated and activated into alarm condition.
How to Arm the System in STAY Mode 2
Hold down the [0] button until two beeps sound. The STAY indicator displays and Exit Time
starts counting.
Any zones programmed to be automatically isolated in STAY Mode 2 flash until Exit Time
expires. At the end of Exit Time, all zones selected to be automatically isolated extinguish and
the codepad emits one short beep.
Bosch Security Systems, Inc.
Enter your user code followed by the [*] button (for example, [2580*]).
Two beeps sound and the STAY indicator displays. Exit Time starts
counting.
Any zones programmed to be automatically isolated in STAY Mode 1 flash
until Exit Time expires. At the end of Exit Time, all zones selected to be
automatically isolated turn off and the codepad gives one short beep.
Hold down the [*] button until two beeps sound.
The STAY indicator displays and Exit Time starts counting.
Any zones programmed to be automatically isolated in STAY Mode 1 flash
until Exit Time expires. At the end of Exit Time, the zone indicators turn
off and the codepad gives one short beep.
User's Guide
Operation with ICON LCD Codepad | en
2017.09 | 04 | F.01U.298.028
13