Remote Arming By Telephone - Bosch Solution 2000 User Manual

24 en | Operation with ICON LCD Codepad
Zone LED
1
2
1, 2
Tab. 5.9: Codepad ID / Buzzer Tone
5.16

Remote Arming by Telephone

Arm your system from any remote location using the telephone. For security reasons, the
system cannot be disarmed using this method. Your installer must program this feature to
operate.
How to Remotely Arm Your System by Telephone
1.
2.
3.
Notice!
If your installer programmed answering machine bypass, call the control panel twice to make
a connection with the system. For example, call the telephone number your control panel is
connected to and let the call ring no more than four times. Hang up the telephone. Wait a
minimum of 8 - 45 sec before you calling the control panel again.
5.17 Domestic Dialing
Use domestic dialing can be used to call your mobile phone or a relative/friend if your control
panel activates an alarm. Up to 8 different telephone numbers can be programmed for the
control panel to call when an alarm occurs. Only your installer can program the system to
report in the domestic format. The Master Code holder can change the telephone numbers at
any time.
5.17.1 Acknowledging Domestic Calls
When an alarm condition occurs, the system calls the first programmed telephone number.
When you answer an incoming call, the system repeatedly emits a siren tone followed by a
pause, continuously for 10 times (for example, siren tone, pause, siren tone, and pause).
If you do not acknowledge the call from the control panel during a pause between siren tones,
the control panel hangs up after 10 times and recall the same call number for 2 times. If the
system still can't receive the acknowledge, the system calls the next telephone number.
Pressing the [*] key for 1 sec to 3 sec during the pause acknowledges the call. No further calls
are made for that event. If the call was successfully acknowledged, a tone of decreasing pitch
sounds.
2017.09 | 04 | F.01U.298.028
Call the telephone number connected to your control panel.
When the control panel answers the incoming call, a short jingle sounds. To arm the
system, press the [*] key on the telephone for 1 sec to 3 sec. If you hear modem tones
when the control panel answers the incoming call, the system was programmed for
remote programming functions by your installer. Wait for a pause between the tones
before pressing the [*] key. After releasing the [*] key on the telephone, two beeps
sound, indicating that the system is armed in AWAY Mode.
Hang up the telephone and the system remains armed.
Codepad Assignment
Area 1
Area 2
Both Area 1 and Area 2
User's Guide
Control Panel
Bosch Security Systems, Inc.