Application Examples - Keithley 4200A-SCS User Manual

Model 4200A-SCS Parameter Analyzer User's Manual

Application examples

This manual provides application examples that show you how to perform tests from the front panel
and over a remote interface. The applications include:
•
Create a new project and test
•
Use the RPM to switch the SMU, CVU, and PMU
•
Configure and use a Series 700 Switching System
•
Make I-V measurements on a solar cell
•
Make C-V measurements on a MOSCAP
•
Use the 4200A-CVIV Multi-Switch
•
PMU for pulsed I-V measurements on a MOSFET
The default settings used for the devices, tests, and projects in Clarius are generally sufficient to
produce usable data when executing a test. However, you may have additional settings you want to
apply when you configure your measurements.
General ratings
The 4200A-SCS instrument's general ratings and connections are listed in the following table.
Category
Supply voltage range
Current rating
Input and output connections
Environmental conditions
4200A-SCS-900-01 Rev A. / September 2016
(on page 3-1)
(on page 4-1)
(on page 5-1)
(on page 6-1)
(on page 7-1)
(on page 8-1)
(on page 9-1)
Specification
100 V to 240 V , 50 Hz or 60 Hz
RMS RMS
1000 VA
See Front panel overview (on page 2-1) and
page 2-4).
For indoor use only
Temperature range:
Operating: 10 °C to 40 °C (50 °F to 104 °F)
Storage: − 15 °C to 60 °C (5 °F to 140 °F)
Humidity range:
Operating: 5 % to 80 % RH, non-condensing
Storage: 5 % to 90 % RH, non-condensing
Altitude
Operating: 0 to 2000 m (0 to 6252 ft)
Storage: 0 to 4600 m (0 to 150925 ft)
Pollution degree: 1 or 2
Section 1: Introduction
Rear panel overview (on
1-3