Appendix A - Advanced Control Panel Features A; Setup: Options - Printek FormsPro 4300 Operation Manual

ADVANCED CONTROL PANEL FEATURES
The printer's control panel has two additional menus for use by the system administrator.
These are the "Setup: OPTIONS" and "Setup: SECURITY" menus. The OPTIONS menu is
used to inform the printer of any "over all" operating variables and of some optional products
which may be installed.

Setup: OPTIONS

The option menu is the third setup menu. To enter it, first take the printer offline. Then press
and hold the setup button for approximately 4-1/2 seconds until "Setup: OPTIONS" appears
on the display and the bell beeps three times. Note that while you hold the button, "Setup:
FORMS" and "Setup: INTERFACE" are displayed as you pass through those menus. At this
time you are able to view and/or edit the values for the option functions listed below.
Although you may select functions with either the FUNCTION UP or FUNCTION DOWN
buttons, they are listed here in the order of function up.
Function
Max Form #:
Ribbon Check:
APPENDIX A"
Possible Values
0 through 9
On* or Off
Description
Sets the last form number to be
displayed for operator selection
with the FORM SELECT button or
while in the "Setup: FORMS"
menu.
Note that when setting this value
that you may not select a value less
than the form currently selected
when setup was entered, or less
than the form currently selected in
the "Setup: FORMS" menu.
Sets whether or not ribbon
checking is active. Turning this
off may limit the warranty on the
print head. For more information,
see the chapter on "Using Special
Features" and refer to the warranty
information in the "Printer
Specifications" appendix.
Page A-1