Printek FormsPro 4300 Operation Manual page 34

Operation
Open the doors on the tractors and remove the paper or form through the slot in the base of
the printer.
Bring the new paper up through the slot in the base and position the holes of the paper over
the pins in the tractors; then close the doors. Position the left tractor as shown on the label
located in the base of the printer. If the tractors are not set at the proper width for the paper
being loaded, simply move the lever beside the tractor door to the open position and slide the
tractor(s) sideways. Space the tractors far enough apart so the paper does not buckle in the
center, but is not so tight that the holes in the paper become distorted by the pins in the
tractors. A properly installed form is shown below. Note that the paper is not above the tops
of the tractor doors.
FormsPro 4503 With Forms Installed
in Front Tractor Path.
Note that the forms do not extend above the tractor doors.
If your printer is a FormsPro 4503, and you wish to install paper in the other tractor paths,
you may do so at this time. If your printer is a FormsPro 4300 or FormsPro 4500, or if you
do not wish to load other paths, proceed to the next paragraph. You can position the other
tractor paths for loading without closing the printer's case. To load another tractor path, press
the UNLOAD/FORM SELECT button on the front panel until the desired form and tractor
path is indicated on the LCD display. Then press the LOAD button. This causes the selected
tractors to move into position for loading. You may now install the paper in this tractor path.
Page 3-14