Printek FormsPro 4300 Operation Manual page 24

Operation
ALIGN UP
ALIGN DOWN
Page 3-4
tractors to be used the next time you press the LOAD
button.
The printer will not allow you to change the form during
printing. If you press the FORM SELECT button while
there is still a line to print, the button press is rejected,
the bell sounds, and the message "Finish Printing!"
flashes on the LCD. If this happens, you should place
the printer back on-line, allow the form to finish
printing, and then place the printer off-line and select the
desired new form.
"Finish Printing!" in the "Using Special Features"
section.
If you press and hold this button at power-up/reset on the
FormsPro 4503, and paper has not been loaded, the
tractor shuttle moves all the way forward to its parked
position. NOTE: The tractor shuttle should always be
parked whenever the printer is being transported.
For a description of this button while the printer is in the
setup mode, refer to "Introduction to Setup" later in this
chapter.
This button is used to adjust the paper in respect to the
current form position.
position, you must insure that the printer is at the top of
form before you make this adjustment.
accomplish this by performing a Form Feed prior to
making the adjustment. Each time you press this button,
the paper moves up 1/72nd of an inch. If you hold this
button down, the paper advances the amount required to
complete a line feed (LF) at the currently selected line
pitch, and then continues to advance in full line
increments. The longer you hold this button, the faster
the paper will move.
For a description of this button while the printer is in the
setup mode, refer to "Introduction to Setup" later in this
chapter.
This button is used to adjust the paper in respect to the
current form position.
position, you must insure that the printer is at the top of
form before you make this adjustment.
accomplish this by performing a Form Feed prior to
making the adjustment. Each time you press this button,
the paper moves down 1/72nd of an inch. If you hold
this button down, the paper moves the amount required
to complete a line feed (LF) at the current line pitch, and
then continues to move in full line increments. The
longer you hold this button, the faster the paper will
move.
For more information, refer to
To adjust the top of form
To adjust the top of form
You can
You can