Appendix G - Printer Reset Conditions - Printek FormsPro 4300 Operation Manual

PRINTER RESET CONDITIONS
The following list describes conditions that are assumed whenever power is applied to the
printer, the SETUP mode is exited, or a reset escape sequence is received (when the printer is
operating in an emulation mode that supports such a sequence).
This list includes all variables that you can modify for all emulations, even though some
emulations cannot modify all of the variables shown. Refer to the appropriate section of this
manual for the emulation you are using.
Variable
character pitch
left margin
right margin
line pitch
form length
top margin
bottom margin
font
impact mode
language
normal/slashed zero
auto cut mode
unidirectional mode
top of form
text in an incomplete line
input buffer
control of data bit 8
control character symbols
italics
double high
double strike
double wide
emphasized
superscript/subscript
underline
horizontal tabs
vertical tabs
APPENDIX G
Reset Condition
according to current form setup
according to current form setup
according to current form setup
according to current form setup
according to current form setup
according to current form setup
according to current form setup
according to current form setup
according to current form setup
according to current form setup
according to current form setup
according to current form setup
according to current form setup
set to current position
discarded
cleared (unless reset from host)
accepted as received
according to interface setup
off
off
off
off
off
off
off
to every eight columns
cleared
Page G-1