Changing The Ribbon; Using Printek Ribbons; Removing The Old Ribbon - Printek FormsPro 4300 Operation Manual

Operation
Caution: When you access the ribbon loading bail as
described below, the print head may be hot if a long
report has just finished printing.
head should never be hot enough to cause a burn, you
may wish to wait several minutes before changing the
ribbon.

Using Printek Ribbons

The use of
Printek ribbons provide the maximum ribbon life and print head life possible. They also
allow the printer's automatic ribbon change indicator system to operate. While it is possible
to use non-Printek ribbons in your printer, doing so will limit the warranty on the print head
and other mechanisms which are used to advance the ribbon fabric. If you choose to use non-
Printek ribbons, you must disable the ribbon sensing system as described in the appendix
titled "Advanced Control Panel Features".

Removing the Old Ribbon

To remove the old ribbon, first open the lid on the top of the printer and lift the ribbon
loading bail as shown below.
1.
2.
Page 3-16

CHANGING THE RIBBON

ribbons provides several advantages. Most importantly,
1
Ribbon Loading Bail in Up (open)
Position.
Ribbon Support Brackets.
Although the print
2