®
AmpFlex
- Flexible AC Current Probes
Maintenance
Warning
For maintenance use only specified replacement parts.
To avoid electrical shock, do not attempt to perform any servicing
unless you are qualified to do so.
Do not perform any service while the AmpFlex
To avoid electrical shock and/or damage to the instrument, do not get
water or other foreign agents into the electronic module.
Also see warning on page 2.
Battery Replacement
If the power ON indicator (green LED) blinks or does not light up,
replace the battery.
Remove the AmpFlex
To replace the battery, open rear case, replace battery and
reassemble. The green LED should go on when the module is turned
on.
Cleaning
It is important to keep the probe sensor latch mating surfaces clean
and prevent foreign bodies from hampering the closing. The sensor
may be gently cleaned with a soft cloth, soap and water. Dry
immediately after cleaning. Avoid water penetration into the electronic
module.
Make sure the sensor, electronic module, and all leads are dry before
any further use.
Shop for AEMC products online at:
®
from any circuit before replacing the battery.
- 18 -
ShopAEMC
www.
®
is on any circuit.
.ca
1.800.561.8187