Section 4: Maintenance And Troubleshooting; Cleaning The Case; Resetting The Robotics; Technical Support - Primera Signature, Inscripta rinter Autoloader Operator's Manual

15

SECTION 4: MAINTENANCE AND TROUBLESHOOTING

Conductor is designed to operate for extended periods of time with very little attention. In fact, no
regular maintenance is recommended other than cleaning the outside case.
IMPORTANT:
Do NOT attempt to oil or grease the Duplicator's Robotic Arm shaft or other components. You will
likely cause more harm than good! Any moving parts are designed to be run for the life of the
machine with no additional lubrication required.
A. Cleaning The Case
Use a clean, white rag with a small amount of water or isopropyl alcohol to clean the Duplicator and
printer's outside cases and CD trays. Stronger cleaning solutions are NOT recommended because
they may damage the paint and plastic materials from which the parts are manufactured. Always
disconnect your Conductor and printer power cords before cleaning. Resume operation only after
the surfaces are completely dry.
B. Resetting the Robotics
If you find yourself in a situation where the robotics are not responding properly, you may need to
do a system reset. A typical cause may be when you stop a job out of sequence. To do so, press
the Pause and Pick buttons at the same time.
C. Technical Support
If you have difficulties in operating your Conductor, the set-up and testing procedures in this manual
should, in most cases, solve the problem. If you still have difficulty, contact the technical support
number listed on the insert included in the supply pack that came with your product.