Section 2: Hardware And Cable Set-Up; Connecting The Parts And Interface Cables - Primera Signature, Inscripta rinter Autoloader Operator's Manual

SECTION 2: HARDWARE AND CABLE SET-UP

A. Connecting the Parts and Interface Cables
Follow these steps to integrate your autoloader and printer:
1. In the Conductor shipping box you will find the Input and Output Bins. Place the Bins in their
correct places as shown in Figure 1. Depending upon which printer you are using, you'll see
that the locations for the Bins changes. Upon power-up, Conductor will automatically detect
which printer is being used by where you place the Bins.
2. Connect the Printer Control Cable that was included with your Printer Stand. Insert it into the
Conductor's rear panel 6-pin mini-DIN socket. Don't connect the other end yet.
3. Apply power to the Conductor by connecting the Power Supply cord to the Conductor's rear-
panel Power Input Port. Don't plug the other end into a wall outlet yet.
4. Attach the Printer Stand to the Conductor by locating the connecting tabs and inserting them
into the appropriate slots on the rear panel of the Conductor. See illustration below for the slot
locations. For the Signature III CD Color Printer, the stand is attached so that it is centered on
Conductor as shown in Figure 6. For the Inscripta Thermal CD Printer, the printer is mounted on
the left side of the Conductor as shown in Figure 2.
Figure 4: Connecting the Printer Control Cable
Figure 5: Connecting Power to Conductor
9