Input Type (Process) - Omega MICROMEGA CN77000 series User Manual

Input Type (Process)

Display Action
INPT
Press MENU
TYPE
Press ENTER
INPT
Press MAX
PRoc
Press ENTER
Press ENTER
Proc
Press MAX
0-10
Press ENTER
Use the Input Type (Thermocouple) (RTD) or (Process) and verify your Dip Switch Setting (see section 2.4) and your Electrical Installation
Note
(see section 2.5). See the previous pages for (RTD) and (Process) menus.
Process Types: 100mV
Display:
Natural Gain 100 cts/mv
Max Display 9999 @100 mv
For 4-20 mA Input select 0-20 mA and adjust the Input Scale & Offset accordingly. To adjust 4-20 mA input. (See example under INPUT
Note
Scale & Offset.)
Response
ENTER INPUT TYPE MENU:
1) Press MENU, if necessary, until
2) Display flashes
displayed input type is Process, press MENU to skip to step 5 (proc stops flashing).
PROCESS SUBMENU:
3) Press MAX to scroll to
4) Display flashes
5) Display flashes previous Process type selection. ie.
6) Scroll through the available Process types to the selection of your choice.
7) Display flashes
Configuration
1V
0-0. 1 0-1. 0
10 cts/1mV
9999 @ 1V
O : C
PERATION ONFIGURATION
"
Inpt type
" " " " "
rtd , t. c , or proc
" "
Proc (flashing).
" "
stored message and
" "
stored message and advances to the next menu
"
.
10V 0-20 mA
0-10 0-20
1 ct/mV 500 cts/mA
9999 @ 10V 9999 @ 20 mA
M
ODE
"
prompt appears.
"
(RTD, Thermocouple, Process), if the
" "
Proc
stops flashing.
" "
0-10 (See below for types.)
part
3
"
Reading
27