Omega MICROMEGA CN77000 series User Manual page 57

Output 1 cont.
Display Action
DPNG
Press ENTER
FCTR
Press MAX
DPNG
0001
Press ENTER
Damping Factor is a measure of speed, overshoot, and undershoot in which the process variable responds to the output
Note
changes of the controller, which were used during the Auto Tune. This value is typically set to the ratio of Rate to Reset.
This Default value is (0003). For fast response time, this value should be decreased while for slow response time it should
be increased.
O
PERATION
Response
DAMPING FACTOR SUBMENU:
40) Display flashes the previous
41) Scroll through the available selections: 0000, 0001, 0002, 0003, 0004, 0005,
0006, 0007, 0008 - Default is 0003.
"
42) Display flashes strd
: C
ONFIGURATION
" "
Damping Factor selection.
"
message and advances to the
part
3
M
ODE
" "
Output 2 menu.
49