part
3
O
PERATION
Turning Your Controller
On for the First Time
16
: C
M
ONFIGURATION
3.1 Introduction
The Controller has two different modes of operation. The first, Run Mode, is used to
display values for the process variable, setpoint value and to display or clear peak
and valley values. The other mode, Menu Configuration Mode, is used to navigate
through the menu options and configure the controller.
Part 3 of this manual will explain the Menu Configuration Mode. For your
controller to operate properly, the user must first "program" or configure the
menu options in the Menu Configuration Mode.
The Controller becomes active as soon as it is connected to a power source. It has
no On or Off button. The Controller will at first flash reset on the PV and software
version number on the SV display, and then proceed to the Run Mode.
ODE