Omega MICROMEGA CN77000 series User Manual page 43

Alarm 1 cont.
Display Action
A. P . o N
Press MAX
ENBL
Press ENTER
ALARM 1 LOW VALUE SUBMENU:
AL1. L
Press MAX & MIN
0762
Press ENTER
AL1. H
Press MAX & MIN
2722
Press ENTER
Latched Mode: Relay remains "latched" until reset. To reset a latched alarm, put unit into ÒStand-byÓ Mode by pressing the ENTER
Note
button twice. Then, enter back into Run Mode by pressing the ENTER button a third time and alarm will be de-energized.
Unlatched Mode: Relay remains latched only as long as the alarm condition is true.
Normally Closed:"Fail Safe" Mode, relay is energized under "normal" conditions and becomes de-energized during alarm or power failure.
Normally Open: If this feature is selected, then the relay is "energized" only when an alarm condition occurs.
O
PERATION
Response
ALARMS ENABLE/DISABLE AT POWER ON:
11) Display flashes previous selection. Press MAX to enable or disable.
If the alarm is enabled at Power On, the alarm will be active right after reset. If the alarm is
Note
disabled at Power On, the alarm will become enabled when the process value enters the
non alarm area. The alarm is not active while the Process value is approaching Setpoint 1.
"
12) Display flashes Stored
"
advance to the Alarm 1 Low Value
15) Display flashes 1st digit of previous value. Use MAX and MIN to enter new value.
"
16) Display flashes strd
"
advance to Alarm 1 HI Value
ALARM 1 HI VALUE SUBMENU:
17) Display flashes 1st digit of previous value. Use MAX and MIN to enter new value.
"
strd
18) Display flashes
"
advances to Alarm 2
: C
ONFIGURATION
"
message only if it was changed, otherwise press MENU to
"
submenu.
"
message, only if it was changed, otherwise press MENU to
"
submenu.
"
message only if it was changed, otherwise press MENU to
"
submenu.
part
3
M
ODE
35