Troubleshooting - Electrolux EOB9956XAX User Manual

The top lamp
1. Turn the lamp glass cover to remove
it.
2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Attach the metal ring to the glass
cover.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or op‐
erate the oven.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
The display shows error
message "F....."
5. Install the glass cover.
The side lamp
1. Remove the left shelf support to get
2. Use a Torx 20 screwdriver to remove
3. Remove and clean the metal frame
4. Replace the lamp with a suitable 300
5. Install the metal frame and the seal.
6. Install the left shelf support.
Possible cause
The oven is not connected
to an electrical supply or it
is connected incorrectly.
The oven is deactivated.
The necessary settings are
not set.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
Electronic error.
access to the lamp.
the cover.
and the seal.
°C heat-resistant lamp.
Tighten the screws.
Remedy
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
Activate the oven.
Make sure that the settings
are correct.
Refer to "Using the Child
Lock".
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Contact an Authorised
Service Centre.
ENGLISH 59