Troubleshooting - Electrolux EH7GL4XCN User Manual

12.4
The number of glass panels is different for
different models.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
2
B
2. Pull the door trim to the front to remove it.
3. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
4. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
22 ENGLISH
on the top edge of
1
Make sure that the glass panels are inserted
in the correct position otherwise the surface
of the door may overheat.
12.5 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
Top lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a halogen, 230 V,
40 W, 300 °C heat-resistant lamp
4. Install the glass cover.
Side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Clean the glass cover.
3. Replace the lamp with a halogen, 230 V,
25 W, 300 °C heat resistant lamp.
4. Install the left shelf support.