Parameter Overview And Data Entry - ABB FSM4000 Operating Instructions Manual

8.3

Parameter Overview and Data Entry

Key Key Symbol
C/CE #
STEP
DATA
ENTER simultaneously
press for an
extended time
Submenu/
Parameter
Information!
If the converter S4 is used with an older flowmeter primary model, then after pressing any
key the menu „Primary Setup" must be entered. If at a later time it is determined that the
entries are incorrect, the entries can be corrected in the Submenu Systemdata „Primary".
See Page 29 and Chapter 10.
Prog Level
Locked
ENTER
24 S4
Magnet Stick Description
# The C/CE-key is used to toggle back and forth between the operating mode and the menus.
For Magnet Stick operation hold over the NS symbol .
N S
The STEP-key is used to scroll down through the menus. All desired parameters can be accessed.
For Magnet Stick operation hold over the NS symbol.
N S
The DATA-key is used to scroll up through the menus.
For Magnet Stick operation hold over the NS symbol.
N S
ENTER-Function press both keys simultaneously
If only the DATA-key is pressed for an extended time, the ENTER-Function is activated.
For Magnet Stick operation hold over the NS symbol for an extended time.
N S
Submenu/
Parameter
Prog Level
Locked
Prog Level
Standard
Prog Level
Specialist
Prog Level
Service
Servicecode?
ENTER
0
Submenu/ Selections
Parameter Value Range
Comments
"Locked": All entries in the standard menus
can read
All standard" Menus are shaded in gray
"Standard": Contains all menu entries
required to operate the instrument.
"Specialist": Contains all customer
accessible menu entries.
"Service": additional menus displayed after
the correct Service Code number has been
entered, only for ABB Service).
D184B122U02