Installation - Beretta Power Plus Box 1001 INT Installation Manual

Condensing
Table of Contents

Advertisement

4

INSTALLATION

b
Power Plus Box 1001
in conformity to the latest provisions of the law
and standards in force concerning heating units,
condensing boilers and/or other applicable regulatory
provisions.
4 .1 Product packaging and
identification
The Power Plus Box 1001 heating unit is supplied, packed
and protected by a strapped carton.
Boiler
1
Control panel
2
EC marking/Symbol cartouche
3
Packaging
4
Polyester corners
5
Polyester protection panel
6
Strap
7
Details of the product are written on the outside: model,
power, version and type of fuel. Contact your local dealer
in case of any differences with the order.
Ensure the goods are intact and complete after unpacking
them.
b
Do not leave the packaging within the reach of
children as it could be a potential source of danger.
The tag on the front side of the boiler's electrical board,
contains the following information:
- Product name
- Serial number
- Product identification code
- CE certification number
- Gas type and pressures from mains
- Power type from mains
- Rated heat capacity (Qn)
- Rated working power (Pn)
heating units must be installed
Figure 6
- Efficiency according to 92/42/EEC Directive (η)
- Max pressure and temperature (Pms)
- Primary system (T)
- NOx class (NOx)
a
It is forbidden to remove or mishandle the identification
plates, markings and any other making it difficult to
safely identify the product.
CONNECTION DIMENSION CONNECTION
Water
2"
distribution
Gas fitting
1"
Exhaust flue
Ø110
duct
Condensate
50 mm
outlet
4 .2 Installation premises
The heating unit must be installed in premises used
exclusively for the latter conforming to standards and
legislation in force and where combustion exhaust
products and combustion air intake is conveyed out of said
premises. Where combustion air is instead taken from the
installation premises then the latter must be equipped with
suitably sized vents conforming to standards.
Figure 7
REMARKS
TYPE
Flow/return
connections
for hot water,
Threaded
high/low
temperature
systems
Threaded
Piping in
plastic
Socked
material
allowed
See
Socked
paragraph
4.1.8
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Power plus box 1001 ext

Table of Contents