Table of Contents
Advertisement
Installation and
Operation
This section describes the following:
z
z
z
Rear Panel Connections
Figure 2.
WARNING:
NOTES:
a
Rear Panel Connections
Front Panel Configuration Port
Controls, Indicators, and Operation
2
2
2
2
100-240V
0.3A
OPTICAL INPUTS
1
2
3
4
LOOP IN
LOOP IN
LOOP IN
LOOP IN
50/60 Hz
1
3
3
3
3
FOX SW8 Connectors
This unit outputs continuous invisible light, which may be harmful and
dangerous to the eyes; use with caution. For additional safety, plug the
attached dust caps into the optical transceivers when the fiber optic cable
is unplugged.
Singlemode and multimode devices are not interchangeable. Ensure that you
•
connect transmitting and receiving devices that are compatible with the
switcher.
Ensure that you use the proper fiber cable for your system. Typically,
•
singlemode fiber has a yellow jacket and multimode cable has an orange
jacket.
In this guide, the term "sending connector" refers to an LC connector that
•
outputs a fiber optic signal. The term "receiving connector" refers to an LC
connector that receives an optical signal.
AC power connector — Plug a standard IEC power cord into this connector to connect
the switcher to a 100 VAC to 240 VAC, 50 or 60 Hz power source.
2
2
2
2
FOX SW8
5
6
7
8
LOOP IN
LOOP IN
LOOP IN
OUT
IN
RS-232
Tx Rx
3
3
3
4
5
Extron FOX SW8 • Installation and Operation
4
Advertisement
Table of Contents
Need help?
Do you have a question about the FOX SW8 and is the answer not in the manual?